IICRC - WRT Exam 2024-2025: Questions and Answers on Humidity, Moisture, and Drying, Exams of Water and Wastewater Engineering

Download IICRC - WRT Exam 2024-2025: Questions and Answers on Humidity, Moisture, and Drying and more Exams Water and Wastewater Engineering in PDF only on Docsity!

IICRC - WRT EXAM 2024-

It is possible for damaging wood (rot) decomposing fungi to grow on wood surfaces if the moisture content is within the range of ______%. THE ANSWER IS 20%

the relative humidity - the result The ratio of the amount of moisture that is suspended in air, expressed as a percentage of the total moisture holding capacity of that air at a specific temperature.

ANSWER Asbestos Containing Material, abbreviated as ACM

The Daily Record of Humidity - In ANSWER The recording of the relative humidity and temperature to calculate the Grains Per Pound (GPP) should take place at least once every 12 for every 24 hours.

Even in areas that are not directly wet, there will be an increase in humidity. Consequently,... - The ANSWER For technicians to achieve the best possible control of humidity, impacted areas must be separated from non-affected areas.

The answer is that vapor pressure will always try to find a level of equilibrium within a limited region at some point.

To what extent does one pound of air include grains? Answer number 7000

answer to the question: humidity ratio/specific humidity The quantity of water in the air, measured in terms of its weight, that is contained within the air parcel.

What is the ultimate goal for drying on day 2? - The ANSWER should bring the humidity down to below 70 percent to guarantee mitigation.

Some people also refer to dew point as ___. Saturation temperature or condensation is the answer when asked.

The Dew Point is the temperature at which the air becomes saturated with water vapor (100 percent relative humidity) and condenses on cooler surfaces. Here is the answer.

Mold can be caused by condensation moisture in what places? - The ANSWER Mould can grow in cold spots in homes and buildings, which are areas where warm air from inside the building comes into contact with cold air from outside, or vice versa.

The Answer Is Fog At the point where the air temperature reaches the dew point.

An answer is dew. Condensation is the temperature at which evaporation is exceeded by condensation.

How might condensation possibly be harmful? - The ANSWER The presence of condensation in conjunction with a biofilm, which is an organic film such as soap or glue, makes it possible for mold to develop on a wide range of surfaces, including plastic and glass.

The answer is biofilm. The presence of any organic substrate and bacteria that tend to promote the growth of mold.

The importance of thermal cameras is discussed. - The ANSWER Utilizing thermal cameras in conjunction with other sensors, it is possible to identify the moisture perimeter of wet carpets and cushion.

The phenomenon of water vapor being able to pass through solid materials is referred to as permeance. The term "permeability"

The items that are considered to be moisture vapor barriers and - ANSWER must be removed are those that have a perm preference or a value that is less than 1.0.

It is possible for water in the form of a vapour to travel through materials without that substance becoming wet.

The ANSWER is ventilation. Wet air is expelled from one side of a room through the opening of a window, while warm dry air is allowed to enter through the opening of another window.

This is a fantastic technique to "open dry."

When is it appropriate to utilize closed drying? In situations where the air from the outside is either too cold or too wet to assist in the drying process.

To be more specific, a closed drying system is utilized in situations when the humidity ratio outside is higher than the humidity ratio within.

When utilizing refrigeration dehumidification, it is imperative that the temperature of the affected area be kept at a level that is as close to 80 degrees as is practically possible.

With all other factors being held constant, what is the temperature that will result in the greatest rise in the rate of evaporation? An answer of eighty degrees

Every single conventional dehumidifier, as well as a significant number of the LGRs, does not function well at... - The ANSWER Extremely high temperatures, over 85 degrees.

How can we achieve the ultimate goal? - The ANSWER Technicians take into account the link between temperature, humidity, and air flow in order to achieve the ultimate goal of having the most effective drying process possible.

The answer is dehumidification. Water vapor in the air is reduced as a result of this.

According to the American Society of Heating, Refrigeration, and Air Conditioning Engineers (ASHRAE), the range of humidity that is considered to be the most comfortable and beneficial to one's health from an interior environment is between thirty percent and fifty percent.

The range of temperatures between 70 and 90 degrees is where refrigerant dehumidifiers perform at their highest level of efficiency."

The refrigerant is the most effective dehumidifier to use when the temperatures are warm, the humidity is high, and the materials are porous.

As a result of its inability to function effectively at temperatures lower than 70 degrees, refrigerant dehumidifiers are not suitable for use in professional drying applications.

In what ways does a Low Grain Refrigerant (LGR) improve the environment? - The ANSWER Dehumidifiers that use low grain refrigerants continue to extract a considerable amount of water vapor, which is lower than that of conventional dehumidifiers.

The relative humidity (RH) must be reduced to below... - ANSWER 70% within the first twenty-four hours.

In situations where the relative humidity is more than 70%, the risk of damage to hygroscopic materials is at its highest.