Docsity
Docsity

Prepare for your exams
Prepare for your exams

Study with the several resources on Docsity


Earn points to download
Earn points to download

Earn points by helping other students or get them with a premium plan


Guidelines and tips
Guidelines and tips

Oil burner License Study Guide(Massachusetts) Questions and Answers 2025/2026 Latest, Exams of Oil Engineering

Oil burner License Study Guide(Massachusetts) Questions and Answers 2025/2026 Latest Update

Typology: Exams

2024/2025

Available from 05/28/2025

BESTOFLUCK
BESTOFLUCK 🇺🇸

4.2

(5)

2.1K documents

1 / 6

Toggle sidebar

This page cannot be seen from the preview

Don't miss anything!

bg1
Oil burner License Study Guide(Massachusetts) Questions and
Answers 2025/2026 Latest Update
What are the 3 funtions of an Oil Burner nozzle? - Answer- Atomize, Meter, Patter.
What are the 2 voltage circuits of a primary control? - Answer- Line & Low.
What is the function of a fuse? - Answer- Protect circuit.
What is the High Limit cut out? - Answer- Max safe Temp or Pressure setting.
What is the High Limit cut in? - Answer- Cut out minus Differential.
What is the "Max" Lockout time for a burner with a 3 GPH Flow Rate? - Answer- 45
Seconds.
What is the minimum stack temperature which will allow a stack switch to work? -
Answer- 400 degrees F
When do you apply a permit to store oil? - Answer- 10 gallons.
What is the "Main" function of an oil burner Primary Control? - Answer- Prove Flame.
Stack Relay must be reset after lockout? True? or False? - Answer- True.
What is the Required minimum height required for fill and vent pipes? - Answer- 3 Feet.
What is the smallest vent pipe used for residential. - Answer- 1 inch 1/4
What size is the oil line for a residential burner? - Answer- 3/8
Largest oil capacity for residential without a license? - Answer- 10,000 Gallons
At what height ceiling would a second thermal switch be required? - Answer- 12'
A typical residential oil burner is also s/u to run Kerosene True? Or False? - Answer-
False
Permit to install an oil burner is issued by the? - Answer- State Fire Marshall
Draft measurements are taken in what? - Answer- Inches of water column
Pressure Relief for a Hot Water Boiler is? - Answer- 30 Psi
pf3
pf4
pf5

Partial preview of the text

Download Oil burner License Study Guide(Massachusetts) Questions and Answers 2025/2026 Latest and more Exams Oil Engineering in PDF only on Docsity!

Oil burner License Study Guide(Massachusetts) Questions and

Answers 2025/2026 Latest Update

What are the 3 funtions of an Oil Burner nozzle? - Answer- Atomize, Meter, Patter. What are the 2 voltage circuits of a primary control? - Answer- Line & Low. What is the function of a fuse? - Answer- Protect circuit. What is the High Limit cut out? - Answer- Max safe Temp or Pressure setting. What is the High Limit cut in? - Answer- Cut out minus Differential. What is the "Max" Lockout time for a burner with a 3 GPH Flow Rate? - Answer- 45 Seconds. What is the minimum stack temperature which will allow a stack switch to work? - Answer- 400 degrees F When do you apply a permit to store oil? - Answer- 10 gallons. What is the "Main" function of an oil burner Primary Control? - Answer- Prove Flame. Stack Relay must be reset after lockout? True? or False? - Answer- True. What is the Required minimum height required for fill and vent pipes? - Answer- 3 Feet. What is the smallest vent pipe used for residential. - Answer- 1 inch 1/ What size is the oil line for a residential burner? - Answer- 3/ Largest oil capacity for residential without a license? - Answer- 10,000 Gallons At what height ceiling would a second thermal switch be required? - Answer- 12' A typical residential oil burner is also s/u to run Kerosene True? Or False? - Answer- False Permit to install an oil burner is issued by the? - Answer- State Fire Marshall Draft measurements are taken in what? - Answer- Inches of water column Pressure Relief for a Hot Water Boiler is? - Answer- 30 Psi

Pressure Relief for a Steam Boiler is? - Answer- 15 Psi How many cubic feet of Air is required for a 1 gallon nozzle? - Answer- 1, If a power vent fails to start or shuts down during operation, will this affect the burner? Yes? Or No? - Answer- Yes A Hot Water Boiler needs a low water cut off if over 300,000 B.T.U's? - Answer- False What is the proper draft setting for an oil burner? - Answer- .02 Inches WC Taco Zones Valves draw .9 Amps? True? Or False? - Answer- True An oil burner tank must be how many feet minimum from an oil burner? - Answer- 5 Feet Minimum What is the gauge thickness for a 220 Gallon tank? - Answer- 12 Gauge What is a good cad cell reading in the light? - Answer- 300 - 1, What is a good cad cell reading in the dark? - Answer- 100, What device sees flame failure and causes it to lockout? - Answer- Cad Cell A boiler has been flooded by recent rain. What would be the most common problem for a burner as a result - Answer- Electrical damage What is the minimum size of pipping for copper and black pipe in a residential installation? - Answer- 3/8 unless over 100 ft If you increased the air on a burner what would happen to the Co2 Reading? - Answer- It would go down If you increased the air on a burner what would happen to stack temperature? - Answer- It would go up Give 2 reasons why draft is necessary? - Answer- Remove flu gasses & efficiency. Would an increase in excess air raise or lower the stack temp? - Answer- Raise Where should a hot water temp operating control not be located? - Answer- Away from the tankless coil What are the requirements for pressure controls for boilers? - Answer- Line Voltage, ( Max 15 psi ) , Mounted on pigtail, and above water line.

How is an electrical solenoid valve wired and where is it installed? - Answer- Wired in parallel & installed to the motor What is a series circuit? - Answer- One path for electrons to flow What is a camium sulfide cell? - Answer- A visual Flame detector How would you test the safety timing on a stack switch? - Answer- Disconnect T 3 Can material other then steel be used for construction of a light fuel oil tank? - Answer- Yes if Approved What are the requirements when installing two tanks together to a common supply line?

  • Answer- Tanks must be level What is the voltage found on the TT Terminals? - Answer- 24v What gauge wire is used for a T Stat? - Answer- 18 Guage Is Carbon Monoxide a desirable flue gas? - Answer- Hell no! What is the purpose of a low limit control on a steam or hot water boiler? - Answer- Maintain boiler temperature for domestic What is a by pass plug used for? - Answer- 2 pipe system How long after the completion of an installation must a certificate of completion be submitted? - Answer- Within 72 hours When must a low water cut off be used? - Answer- All steam boilers and hot water boilers over 400,000 btu's What is the flash point of #2 fuel oil? - Answer- 115 What is the minimum size oil line on a domestic system? - Answer- 3/8 copper or black maul able Give two reasons for a high stack temperature? - Answer- To much air or sooted boiler What is the greatest loss in a boiler? - Answer- Heat loss How much air is needed in a confined space? - Answer- 50 cubic feet per 1,000 BTU's What is the max voltage of a burner circuit? - Answer- 150v

What is electrical continuity? - Answer- Complete path What is a parallel circuit? - Answer- More then one path for electrons to flow What is the function of a draft regulator? - Answer- To maintain a steady draft What are the five parts of a Backarach smoke test kit? - Answer- Draft Gauge, Smoke pump, Co2 analizer, thermometer, & effiency chart. What are two reasons for a lockout on a stack switch with combustion established? - Answer- Dirty Helix or low stack temperature What is the function of the hot contacts on a stack primary? - Answer- Power the motor What do six terminals on a stack switch go to? - Answer- 1) Hot 2) Neutral 3) Motor 4) Transformer, TT to Thermostat When is an oil gauge required? - Answer- Any tank with a fill and vent pipe When are swing joints required? - Answer- When ever you need pitch What is a power burner? - Answer- Any burner other than a gravity feed or a pressure feed Why are low voltage t stats used more then line voltage - Answer- Main reason because low voltage ones are much safer. Also low voltage t stats are more accurate and less expensive Is it permissible to use manually operated smoke pipe dampers - Answer- Yes, on sleeve burners only. How is a stack switch put "in step"? - Answer- Pull out clutch arm a half inch or so and release slowly. This aligns operating contacts. Cold contacts will close and hot contacts will open. A hot water boiler is showing 12 psi, How far will it raise the water? - Answer- 28ft What would you use in case a suction line to a burner developed oil leaks & to maintain pressure to the burner? - Answer- OSV Carbon monoxide is a result of what? - Answer- Incomplete combustion A high limit operates be sensing what in a hot water boiler? - Answer- Temperature Modern equipment employs the use of power vents, What makes this possible? - Answer- Pre Purge- Post purge controls